![]() ![]() Here are a couple of things that may perhaps confuse the matter and perhaps explain some things.Īs some may have found out micron size of the abrasive is not everything I agree auto care products and pumice/rottenstone just add unecessary steps in finihing your pens. Yes, will use 4F pumice paste (mixed with either mineral oil or water) on other turnings to finish the finish and reduce sheen. ![]() ![]() Again never, want to use on assembled pen. Pumice and rottenstone fine abrasives used to finish the finish (rubbing out) by wood workers for very long time, except for refinishers and traditionalist not as popular these days. Stopped doing that because felt wet sanding and polishing with micromesh lot easier. I also used One Grand STC, after final coat of lacquer finish. Not sure when it dawn on me to stop doing that unnecessary step. Continued with that procedure even after picking up some Hut Ultra Gloss plastic polish. I used One Grand Special Touch Cleaner on acrylic pen blanks to remove scratches after going through wet sanding and polishing with micromesh. Can also use to help reduce finish sheen (shellac, varnish, and lacquer) on pen blanks. Really depends upon what you are trying to accomplish, wax is merely a decoration it is true of scratch removing products too.Īuto rubbing compounds may help remove dust nips in final film finish. They do make auto care product that do not contain silicone. Also do not confuse particle size with hardness of the abrasive particles. Using micro mesh or buffing compound will damage the finish, like going from a 1200 grit finish to 200 grit sanding.Īs for the micron size goes he did not know the exact particle size as it is a range but to remove 600-1200 grit lines it would have to be SMALLER size. So in short sand with paper down to 600-1000 grit, then use Novus #3 on a paper towel, if there is a haze use novus #2, if not then use novus #1 and NOTHING after that. it leaves a silicon residue on the surface to help reduce dust and fingerprints on the item. #2 will EASILY remove the scratches left by 1,200-2,500 grit sand paper. Novus #2 is a somewhat soft abrasive, meaning the hardness of the particles that it contains is not that hard. The 1:1 macro shots I took recently showing compound in the wood pours can be removed with #1. They tell me that #3 *may* leave a haze but #2 will take that out. #3 will remove the scratches from 600-800 grit sandpaper, EASILY, due to the HARDNESS of the particles. Novus #3 is a harsh abrasive, meaning the hardness of the particles that it contains is very hard. Yes indeed Greg and Larry's info that novus 2 is 5.5 microns is indeed incorrect. I just spoke with the novus company about #1, #2 and #3. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |